7-11
Device (Camera) PTZ Setup
If you have a Pan Tilt Zoom camera, use the PTZ tab in the Device (Camera) menu (see image below). At
the present time, the soware supports the following PTZ camera protocol: Fine CRR1600, Kalatel KTD312,
LG_LPT_A100l, Pelco D, Pelco P, ORX 1000, Samsung SSRX1004, Samsung SCC641, Sungjin, Vicon, and
Unitec. Check with the technical support department if your PTZ camera is not on the list as we are adding
to our PTZ library. To set up PTZ camera, click the PTZ tab and select the camera port that the PTZ camera
is attached to. Use the up and down scroll button to nd your camera’s protocol. Next, use the up and down
scroll button to enter the PTZ camera address in the H/W Address box (1-255 is available, but your particu-
lar camera may not support all addresses. See camera documentation). Next, click the setup button to set the
baud rate and communication settings. Click OK and yes to setup value stored. Click return to move to the
main Camera Device menu.
Click Dynamic PTZ tab to begin PTZ camera setup.
Select the camera port where
the PTZ camera is attached.
Use the arrows to select PTZ camera protocol.
Use the arrows to select the PTZ
Camera’s hardware address.
Click the setup button to enter the communi-
cation information for the PTZ camera
Enter hardware communication
settings for the PTZ camera. Refer
to PTZ camera for these settings.
Click OK to return to save
the settings.
Comments to this Manuals